The fencing needs minor repair to self-closing and self latching gates currently the fence does not self close or self latch and also drags at the bottom of the fence.

The fence does not swing away from the swimming pool and therefore needs repair.

$125 - $250 to fix these issues.

The pool surface overall is in fair to good condition.

Discoloration occurring at the bottom of the deep end of the pool this is most likely caused by improper water balance techniques (Pouring granular chlorine or pure acid straight into the water in the deep end and not circulating the water for 1-6 hours after depending on quantities).

This condition will not improve over time and has potential reduced the life of the plaster in half.

The other plastering the school does appear to be in good condition.

Also Note pebble Tec is going to be a more course and abrasive plaster compared to a smooth plaster finish.

There is no loose or missing tile anywhere in the swimming pool.

There is little to no calcium buildup on the tile surface.

Quality overall is very poor despite it's clear presence in the summer it will be very cloudy and less half if not all of the water is drained and refilled or the water is rebalanced to proper levels.

The skimmer is in working condition. There is no loose or missing pieces present.

The main drain is not VGBA compliant and should be replaced with a safety drain cover ($88).

The bottom cleaner is in good working condition, however it has several items that need attention to ensure proper working condition;

1. The bag has a tear and is in need of replacement ($55)
2. The hose has prematurely worn hose swivels due to improper water balance, recomend replacement $22 x 2 ($44)
3. The tail sponge is worn and in need of replacment ($10)
4. Bottom cleaner repair service to clean all internal hoses from debris plus perform all repairs above ($45)

The autofill is an older metal style fill, it is in working condition however during use it does leak from its main seal. This should be opened, cleaned, and re sealed, or replaced ($125).

The pool light is not in working condition at this time. The switch was located and the light switch GFCI was also tested. Breaker received powed and the light did not power on, recommend repair with your pool light.

The filter pump has a 6-9 year old pump motor on a 7-12 year old pump body. This shows signs of issue with either plumbing or running dry. I would expect this pump motor hp is either slightly too high (1.0 hp / 1.65thp) for a 1 1/2" intake plumbing (30-45gpm recommended) currently running 60-95 gpm. Or the pool water level is not monitored often and lowers too low too often (not likly).

The booster pump is 7-12 years old. I would expect this booster pump to last another 1-4 years only.

It's also using the older style hose connections and hoses ($110). I would expect these hoses to last another 1 - 4 years only.

The timer is currently in working condition the timer housing is older while the timer internal mechanisms are new or I would expect the internal mechanisms to last another 10 to 15 years all the outside housing to last the same.

The paint on the timer housing needs to be re-sprayed and UV protected ($10).

Valving is metal and plastic.

Virtually everything on the equipment pad is plastic, and everything underground is metal copper.

I would expect the need to update the plumbing to occur in the next 1 - 15 years ($4-5,000).

I would expect the need to update the metal valving ($455) in the next 1 - 24 months.