Access was through home.

The pool surface has failed and is currently no longer holding water recommend either re-fiberglass ($3500-4000) or replaster ($2500-3200) to ensure the pool surface is watertight.

The tile is in good shape overall with only the skimmer missing tiles ($350). Recommend replacement to confirm the area is water tight.

There is calcium build up that should be removed in the next 1 - 5 years ($350-400).

The water quality overall is fair however there is some modification that needs to be done to the cyanuric acid levels, phosphate levels, and enzyme levels. Recommend treatments ; $175-250.

The skimmer appears to have been modified several times. It currently appears to have missing tile and gaps in the water block. You can either additionally seal this area ($250+) or you can replace the entire skimmer ($2500) (I would expect that replacement would then allow main drain circulation via repair or new line ($1500-2500).

The main drain cover is not vgba complaint. Replacement cost ($88).

The bottom cleaner installed however I do recommend a suction side bottom cleaner for this pool that we connect in the skimmer. Since there is no main drain suction line I would recommend installing such to ensure proper main drain suction.

Note as with the skimmer opening it is a direct connection from the bottom sweep to the pump. This is a high entrapment danger and a vgba certified mechanism ($575) or a vgba compliant vacuum loss pump ($1325) should be installed for safety.

There is no auto fill or manual fill device installed that I found.

The pool light does turn on and function however there is water present inside the lens there for the whole light should be replaced ($575)

The light breaker also is not GFCI compliant and currently does not function as it should recommend replacement ($155).

This is a DE filter it is currently in fair condition the band is currently damaged and should be cleaned and repainted to ensure the metal doesn't degrade further and require replacement ($203).

The filter is currently dirty and needs to be back washed ($65) and or opened cleaned and repacked ($155) with new de after the grids are cleaned sufficiently.

The filter pump motor is like new. The filter pump housing however is older and approximately 10 to 15 years old. Because the solar is on the roof it may have been believed that a higher horsepower pump motor would be required however since the filter pump only has approximately 1 inch and a quarter of a suction line only 60 to 70 gallons per minute can be processed through that opening and only a one horsepower or smaller sized pump should be fitted on this filter pump housing. New motor approx cost $555. Please note that this motor will fail in the next 1 to 48 months.

Also there is no bonding wire attached this filter pump. This should be corrected for safety; $125-$250).

The timer clock is in fair working condition. It is missing it's wire protection plate ($15).

This solar controller is in working condition however it does have a temperature sensor that is currently failed with replacement it will allow this controller to function as it should ($175).

Overall the valves and actuators and check valves all need to be opened cleaned lubricated and resealed to ensure proper operation for the next 10 years. That should be done every 10 years and it does not appear to have been done in the past 10 to 15. Also the check valve needs to be replaced as the internal components can be easily replaced and swaped ($155).

This entire equipment pad needs to be painted with UV protected paint and the filter as well as filter pump should also be painted in someway ($255).