The fencing was in non self closing self latching shape.

The surface of the pool is in poor and damaged condition. There are many areas of potential exposed gunite throughout. Recommend replacement plaster ASAP ($3800-4200) as well as potential structural reinforcement issues ($800+) (ie rebar has been exposed in several locations to water this degrades the rebar shell as a whole).

Recommend a structural engineer review these photos as well before during and after replaster.

The tile has no loose or missing sections.

There is light calcium build up, it will cost $450 - 500 to remove.

The water quality is in overall good condition.

The skimmer has good flow, allowing the skimmer weir to open and close.

Note the skimmer weir is dated and will need replacment $55, (it is the tabed version).

The main drain is not a VGBA compliant cover, to replace with a single VGBA compliant cover expect a cost of $88 for the cover.

To replace it with a VGBA flush bottom drain expect a cost of $300+ during replaster.

The bottom cleaner is in fair to good condition. Note the unit has dealt with over chlorination and chlorine tablets in the system via skimmer baskets for 3-6 years. This will cause internal components to fail in the next 1 - 5 years, expect a cost of $250-$450 in replacement parts for this unit, however once repaired this unit will work well for 10-20 years. Vs a new cleanr $623 installed.

Recommend minor adjustment service $45 + parts ($55+)

The auto fill has a small leak on the top of the valve handle. This should be repaired as it can leak considerably ($55).

This pool light appears to be original and in good to fair working condition due to age.

The filter is in fair physical condition. It may last another 1 - 7 years without issue. However currently there is a small leak locaed in the north west corner of the unit. I cannot identify where the leak is coming from. If the tank is leaking through the platic expect a cost of $300 to replace the shell bottom. To replace and seal o rings expect a cost of $200+.

Note the pressure gauge is not working ($55 pres assembly).

The filter pump is an energy efficient two speed designed motor and single speed designed pump.

The computer module is in good working condition that controls the pump motor.

However the pump motor is hot and may be showing signs of failure due to high heat during operation, or it may just have dirty / high filter pressure. Recommend cleaning filer and if still hot during low speed operation expect a cost of $450-$550 to replace the motor in the next 1 - 12 months.

This timer board has no working GFCI breakers installed ($155 each installed)

Recommend installing such on the pool pump and light GFCI approx cost $305 installed.

All valves installed (2) are in good smooth working condition.

All piping and valves need a fresh coat of UV protectant paint. Expect a cost of $125 to do such.