The safety fencing does not self close or self latch at this time. Recommend repair for safety. The gate access should also swing away from pool.

I would expect this plaster and pebble surface to last another 7-15 years without issue.

I would expect the gunite areas throughout the plaster to not hold water and cause a small amount of water loss over time. This can be resolved by placing a small layer of plaster over the gunite to ensure water proofing ($1500).

There is no tile installed. There is only a gunite shell and a plaster surface. There is medium build up on the gunite surface / water line / and commonly exposed areas of waterfalls. To remove this calcium expect a cost of 600-700.

Overall the water quality is damaged and in need of adjustment, recommend water balance to remove foreign contaminants ($250)

Skimmer - There appears to be a built in / removable reverse float valve installed in this skimmer basket. Recommend removing and replacing with like new unit and re sealing this device.

Pool Main Drain - The pool main drain is not up to VGBA complaince, recommend replacing with a VGBA compliant drain during re-plaster ($300) or in the mean time, replace with a VGBA compliant cover.

Spa Drain - There are two main drain covers in this spa body. They are less than 2 fee apart and therefore not VGBA compliant. Recommend during re-plaster upgrading this to VGBA standard. In the mean time, replace with a VGBa compliant cover.

The bottom cleaner is missing its bottom protective base plate. No doubt through countless abuses due to a long un-fitted hose this units body has taken a prolonged abuse.

Recommend replacement of bottom cleaner $623. Otherwise approx $280-$380 in parts will be necessary to bring this unit back to new.

The auto fill float is damaged and in need of replacement $55

The shut off for the auto fill is located near the north west side of the home.

The pool light is in good working condition. No issues found at this time.

There is also a fiber optic pool light / waterfall light installed using fiber spiders, they are in fair working condition at this time.

A pool light typically last 10 years, replacement is $455
A fiber optic tower light typically lasts 7 years, replacement is $955

The fiber tower is in good working condition however it does need a cleaning service; $155 to clean debris and foreign objects.

The spa light is in good working condition. No issues found at this time.

This Pentair Cartridge filter is in poor condition. The pressure is high and in need of an immediate clean, however with this prolific algae issue and due to the age of the unit I would recommend replacing the filter elements with 4 new cartridges ($250-350).

At time of cleaning, recommend lubricating and cleaning all the o rings on this unit and every ten years ($105).

The bootster pump connections are in need of attention and repair ($125) recommend repairing this item, however note this booster pump should only last another 6 - 24 months before replacement will be required due to age and its worn out status; decay on casing, sound of bearings, and overall sun damaged condition ($525).

This spa jet pump is worn and used, with a leaking return connection, and no longer in use due to a suction side leak. This pump may last another 6 - 24 months if you fixed all issues present. Recommend replacement with like pump. At that time replace and upgrade the check valves.

This Pentair Whisperflo pump is in fair to poor working condition, however due to a leaking shaft seal it is considered damaged and in need of repair. Due to the age of the pump and motor, I would recommend replacment of the motor ($350) before replacement of the entire pump ($775) due to the quality of the pentair pump; fair and therefore the housing may get another 5 - 15 years.

This Pentair Minimax N7 is not in working condition at this time. It does power however it does not turn on its blower or ignaition controls. Recommend investingating the sensor array, this will most likely resolve this heater issue; $125 service call + parts $100-150 vs a new heater $2895.

This Compool LX 3800 Timer is in damaged, working condition.

The unit does function all pieces of equipment, however due to age this unit may only last another 2 - 6 months before replacement may be required ($755-$2200).

Recommend replacement.

Pool light fiber pictures shown here.

Overall all valves (o-rings) and check valves need to be either replaced and or serviced. Expect a cost of $455-1050 to bring this equipment pad to a; cleaned, lubricated, working condition.

Also the entire equipment pad should be painted with UV protectant paint ($155) to ensure proper UV protection.