Fair condition access fence. Older but working.

Approx age of surface is 19 - 23 years old. Plaster like this; in this condition, typically lasts up to 30 to 35 years before water loss begin.

There is wear present on approximately 50% of the surface or more, but again is common with this surface type + age, it may have additional remaining life depending on ongoing maintenance attn. and water loss status.

Also note there appears to be a stain in the deep end (initially suspected rebar stain) and two subsequent stains nearby that are in line and since they are in such a perfect alignment. It is likely that something just simply fell on the pool surface / stayed on the surface and stained it. Recommend a minor treatment to confirm ($100+)

A pool this size would run approx 12-15k to resurface (re pebble plaster) when desired.

The water line tile and raised wall has some calcium build up, but overall no major build up present - can be removed if desired ($700+).

The waterfall has wear of mortar present as it appears to be used frequently, to re mortar this fall needed soon expect a cost of 1-2k+

Water level seems 2”+ lower than normal, auto fill float may be due for service (described in Autofill section)

There appears to be an auto drian 1” line pictured - likely due for minor service / confirm plugged ($50+)

Minor adjustments needed = cycle some new water in, otherwise ideal, no obvious algae seen.

Drain / cycle $100+

The main drains and wall equalizers are due to have their covers updated ($200x4) for safety due to age and condition.

Also recommend updating the weir door, lid, weighted basket, float / float o ring ($500 or less).

No connected unit present. Just a robot wireless unit present. Appears 2+ years old. Typical life span is 3-5 years.

Was not able to open the lid to check the fill. Water level lower than normal but not running, could have been adjusted or due for service more likely due to age due for service = 125-200+ and also lid $50+

There is a single pool light present does not appear to be working, recommend updating the light can ($250-1250) + labor $400

Older, sun beaten, leaking, due for service now = new elements $300-500+, new pressure gauge $50+ , new tank o ring $50-100+ , likely new band soon / now $300+ and service $150+

Or a new like filter costs $850-950+ labor

AquaStar plf 35000 for example.

Hot motor, high energy usage, water loss seen but undetermined if coming from the pump or its return plumbing, recommend repairing the return plumbing and then confirm status of pump , a new better efficient variable speed pump like a Pentair Superflo Vs is $1200+ , if this pump is leaking it would likely be the shaft seal / seal plate area (a $700-1200 repair min) and the remaining pump life should be 1-10+ more years or good life left.

Recommend updating to GFCI ($400+) for filter pump , and light breaker and plug breaker + electricians cost $350+

No longer being used and discussed elsewhere in the report. To update new cell and controller ($1500-2500+

Salt conditions present for likely a decade+

Also very unusual setup that requires the waterfall to be used WITH ? Return jets , otherwise only return cleaner wall port ? This is less than ideal for circulation and on going maintenance (algae control). Recommend isolating the water fall seperate so it can turn off and only be used once or twice weekly for instance vs always…. Recommend service to confirm ($101+)

Recommend covering / painting and labeling ($300+)