No access seen. Must be unfastened to access.

Main gate needs adjustments to self close and self latch.

Older. Heavy wear. Last 10% of its life cycle.

Cost to rePlaster is 10-13k+

The skimmer obviously has been updated in the past 20 years, the throat connection, though is older and should likely be updated at the next resurfacing ($1k+) otherwise everything looks ideal on it at this moment.

The waterline tile is all original, but in seemingly good condition with some updated tile around the east side old spa wall.

High Chlor / ph / alk and cal hardness

Low CYA

Water loss is likely, seen on equipment pad and also the surface is older, likely over older plaster …

Recommend algae treatments asap as black algae is present, recommend those specific treatments ($300+ and other adjustments including modifying the out of balance chemistry ($100+)

Recommend adding a float and float O-ring, and a weighted basket ($200 or less).

It appears that there are two main drains present, both have an updated 10 inch cover, it is possible that this cover is older than seven years, and therefore should be updated for safety at $200 each x 2.

The main unit itself is in good shape, likely updated, but the hose and backup valve are older and due to updated ($150+ and tail needs adjustments / sponge soon = total is likely $205+

The hose is connected into a hub of valves … it is possible one of these is connected to the pool ?

If not recommend adding an auto fill ($40-80) + hose ($40+) = $250 or less

There are two pool lights installed. It is likely that they are older than 30 years. Both of them they are both due to be updated due to age and condition.

Approx cost for light can $700+ x 2 and install $400 x2

Working, near new, over due for service to elements ($150 or less) which may include updating the elements after algae treatments ($400+).

And since Heavy algae is present i feel it would be best practice to replace the elements if elements are older than 2 years (most likely).

Working without issue. Recommend pump lid o ring / basket service ($50 or less).

Working without issue in the unit.

It appears the return fitting / hose connection is leaking - recommend attn to hose connection / service (likely $205 or less).

Recommend updating to GFCI / Sub Panel $700+

No longer in use.

Pad has been painted and labeled recently, and is overall older that has little updated on it after the filter return. Recommend covering from the UV = using a UV mesh $50+