De-lam cracking in spa seats and walls, new re plaster needed $3500+ in the spa minimum.

To also re plaster the pool + $5-6k+

Note the pool is in fair condition overall, many blemishes / discoloration but nothing too damaged - other than shallowest step / ledge is of most eventual issue.

Issues Seen at spa spillover , likely some attn is needed at the water fall as well.

Spa spillover may run 2-3k+ ideally done at time of next re plaster.

Waterfall re waterproofing ($1-2k)

Also note that the coping has been painted, and it is beginning to come off substantially around the pool and spa - approximate cost to remove is 1-2k +

Approximate cost to reapply $1-2k+

Some trip hazard concrete edges can be grinded down (most seen at south west side of pool) 1k+

Recommend chemical treatments for algae ($375+)

And balancing the CYA and ph / alk ($100)

There are four main drain covers in the pool, and there are two in the Spa, all should be updated for safety ($200x6).

There is one skimmer, recommend updating the float O-ring / float and weir door ($200 or less)

Robot cleaner present. Older. Poor condition overall. May have been recently serviced. Unknown working status.

I can hear the auto fill running continuously in the bushes, I cannot access the fill canister easily, recommend attention to the fill canister, verifying if issues or present to the float ($125-250+)

The pool light has condensation inside the light lens recommend updating for safety ($200-1250+) labor / programming $400

The light can has condensation present inside the light lens recommend updating for safety ($200-1150) + labor $400

Older filter, due for quarterly service ($150 or less), to confirm if elements are due for updates ($500+) likely, and if o ring set is due as well ($300 or less) which we are seeing a leaking drain plug so it is likely. And a new gauge ($50)

Working. Signs of age / salt condition wear / lid o ring is due for attn / new basket maybe soon ($100)

Otherwise without issue at this time.

Working. Older. But without issue.

Recommend lid o ring / basket soon ($100 or less).

Good / Fair Working. Motor has some signs of struggling / bearing grinding / heat. May be nearing expiration soon 1-10 years. Cost for a new like pump $1-2k + install $800.

Through much effort the spa heater did not turn on, and showing errors. Likely heater has expired / near expiration.

New heater is approx $5k
+ labor $1k to install.

Working. Recommend updating to GFCI breakers for variable speed / plug minimum ($300) + electricians fee ($400)

Panel works but likely needs programming / instruction ($300 or less)

Likely the cell has expired due to age and condition ($1k+) as well as likely loss of salt ? Recommend service to confirm ($300 or less).

Note the salt cell has a broken union and likely a dead check , to update these expect a cost of $500 or less.

Recommend a uv mesh and labeling ($200) for this pad.