The surface is compromised in several locations, there is a 1 to 2 inch differential between the middle and the ends of the pool / settling.

The surface overall is in damage condition with entry steps and edges, showing signs of issue.

Likely this is no longer repairable due to movement / splits / age.

Cost to remove this shell and replace is likely 20-40k+

Surface has multiple cracks seen. No longer due for use.

Spa is seperate and also un even / not level - spa clarity is very very low about 10% can barely see the bottom of the middle deepest part.

The waterline tile is coming off in The Pool in several locations and is likely due to be updated in both The Pool and the Spa if so, the cost would likely run between 2 to 5000 depending on options.

The concrete decking around the pool has some movement obviously, especially around the spa. We see some cracking. It will likely require this concrete area around the pool and some regard to be potentially cut out and updated to match the proper level of The Pool ($5-20k+)

Recommend adjustments $100

There is no main drain in the pool and the spa could not be checked, additionally, the suction side, bottom cleaner is taking the place of the main drain.

There is one skimmer on the pool and one on the Spa.

The skimmer on the The Pool has an access while the skimmer on the Spa does not

Recommend service to both skimmers to service them and update their parts. $500 or less.

The bottom cleaner is a Hayward navigator, and it could be updated to “the pool cleaner 4 wheel” - $500 + Pentiar in line leaf $100

I wasn’t able to check the auto fill canister, but I recommend servicing this canister and float Once accessed ($125-250 or less).

There is one LED mirror pool light installed. It appears to be a treo by Ao smith … I was unable to get it to turn on, but if needed, the light can be updated for around $400 + labor $500+

The filter is overdue for service, the pressure is high, the pressure gauge is due to be updated ($100) , likely the filter elements are due for replacement ($400+) likely the tank O-ring is due for updating as well ($100)
+ service $150

This filter pump is in working condition without issue at this time note that it is a less than one horsepower pump and susceptible to high pressure issues which we currently have.

Still recommend minor service to the Pump, Lid o, ring and new basket ($100 or less).

Is Pump appears to be in good working condition without any major issue except for a simple pump lid O-ring service, and likely pump basket updating ($100)

The panel is due to have its breakers updated to GFCI for safety ($400) this would include the plug breaker being updated as well (electricians service call $350+).

Note the plug has a transformer that has come apart…

They’re also appears to be a secondary controller off to the side, as controlling actuator functionality.

Recommend servicing the equipment pad with new paint new labeling + covering from the sun, using UV mash ($400)

Also, three three-way valves are due to be updated and serviced plus the one check valve ($1k+).