Locked gate.

The surface is older, pitting, present, and check, cracking or scratches seen in the deep end.

I would not anticipate the surface lasting too much longer, the cost to Plaster this pool would likely run between 6 to 10,000

The waterline tile is likly the original older than 30 years tile and is nearing updating mortar, the only area of current concern is inside the skimmer throat, which appears to have been updated in the relative recent past… still may need attention as I am seeing lifted tiles / signs of movement ?

Additionally, the coping stone around the pool, especially on the east side of the pool and some of the west side has missing mortar and is noticeably very loose in a danger near the skimmer, lifted slightly / trip hazard and will need immediate attention.

Additionally, there is some gaps forming on the right hand side or the east side of the pool coping between the concrete and the coping. This may need to be filled in and or grind it as well.

Approx cost to address all of these issues is 3-5k+

Overall clean and clear, hard to tell if surface is stained (most likely) or some organic build up (least likely).

Recommend chemicals to balance chemistry $200

For an unknown reason, there is rust coming from the center of the main drain, recommend attention to confirm issue ($300 or less)

The skimmer is due to have a new weighted basket ($50 or less), otherwise ideal.

The bottom cleaner unit is relatively new and in fair condition recommend only minor modifications, which will include one or two new tires and a new tail soon not now though ($105 or less).

Note the bottom cleaner unit was getting stuck on the steps in the entry recommend adjustments to resolve

Working. Hose connected. Running constantly. Recommend checking to confirm if fill is still set at correct level / in ideal condition ($20)

The pool light looks relatively new however it appears that it has minor condensation present inside the light lens, and therefore should be updated for safety. Additionally, it does not turn on ($500 light can + labor $400).

Working Condition, filter element is likely newer / recently serviced.

No major issues seen. Like new.

No major issues seen. Working. Like new.

Seemingly newer, very hard to see due to HEAVY foliage coverage , recommend moving the pump to accommodate service / use ($100 or less to dig out debris) and ideally resolve the return leak via hard plumbing instead ($500) or a lower cost option is simple service ($200 or less).

There is a dual timer set up, but they are not being used in that fashion. Both timers are incredibly covered with landscape foliage. It appears the older plug is due for service, recommend updating to GFCI, and also recommend updating the pad to a GFCI subpanel ($400+ electricians service $350+).

It appears on the return side of the filter. We have an older valve that will likely need to be cut out and replaced as well as an old energy bowl that will need to be cut out and replaced for less than $1k in parts and labor.

That will include repainting and relabeling the pad and covering from the sun using a UV mesh.