Mastic is cracked all throughout the pool, some areas worse than others. Recommend replacing all of it. Recommended cost is $1,850.

The skimmer is cracked. It needs to be replaced, and a new one installed. Once a new one is installed, a new expansion joint is going to need to be done so the same thing does not happen again. The estimated cost to perform this service is $3,850.

The pool light is working totally fine without issue. The junction box where the light has the cord pulled through and is wired, however, does not have the cover properly fastened and is prone to getting water and shorting out the entire system. The box needs to be properly covered to also avoid people from getting shocked. Estimated cost to install this cover is $50.

Spotlight is no longer working. To replace this Spotlight, estimated cost is $1,500.

At the bulkhead union of this filter is leaking, it needs to be taken apart and rebuilt. Estimated cost is $485.

This pump drive is having issues. The digital display is no longer working. You cannot see anything on the screen. This drive needs to be replaced in order to have control of this pump and be able to change the settings. It is so expensive to replace the drive. This entire pump should be replaced due to its age. Estimated cost is $2,600.

This spa jet pump is at the very end of its life, exceeding its life expectancy of 10 years. I estimate this pump to be around 12 to 15 years old. It is not going to last much longer. It is going to need to be replaced soon at the cost of $2,600.

This heater is halfway through its life. It is working totally fine at this time with no issue. However, there has been a rat's nest found inside of the heater, but no damage is being shown at this time. It is recommended to put a wire mesh near the vents on the outside to keep the rodents from continuing to make their way inside and causing damage. This heater does not have a bond wire secured and is not safe and up to code. Furthermore, this heater needs to have a drip leg installed to be up to code and to have a sediment trap in place as intended to keep debris from going into the heat exchanger and damaging the heater. The estimated cost to install the mesh for rodent prevention, install the drip leg, and bond wire is $900.

The heater's automation temperature sensor is leaking. Cost is going to be $500 installed.

Salt cell is functioning at this time. However, it has a leak. Estimated cost to fix the leak is $250.

The spa bypass valve is built incorrectly. It needs to be replaced. It is adding too much restriction and causing the spa to be difficult to overflow into the pool. Estimated cost to rebuild is $750. Check valve is showing some major corrosion and definitely should be replaced. In fact, this check valve should be removed. There is no point to having it, and it is adding an unnecessary restriction to the system and making everything pointlessly less efficient. Estimated cost to remove it is $250.