Overall ideal. Approx 7-10 yrs or less. Blemsihes seen on steps. Deep end walls.

The waterline tile appears to be older likely original over 25 to 30 years old, tile issue are more noticeable on the west end of the pool, where the mortar is beginning to separate from the coping area and showing its age. The Tile overall is likely due to be touched up / re mortared soon and or serviced soon (1-10 years or less) - $1500+

The coping is beginning to loosen most noticeable throughout the pool, and there’s a few few spots around the skimmer that need to be touched up for safety, otherwise a Concrete has settled, but no noticeable cracks larger than a dime - due for mastic / attn ($1-2k) - due now

Some calcium build up present but nothing too heavy. Just areas of light and medium build up.

Very high chlorine levels, also high cya. Recommend drain and refill of at least 50% ($300 or less) of the water to allow proper re balance.

Main drain appears VGBA compliant - recommend a closer look to confirm.

Older skimmer, likely original 35+ years.

Recommend only updates ; float - float o ring - weir door - lid ($500 or less).

Note that the skimmer is original and is the screw in style, and may develop issue, soon and ideally should be updated in the next 1 to 10 years or less ($1500+) which is relatively easily done, and gives you an opportunity to hard plumbing, a second main drain line, which is most ideal ($1k+).

Due for service , wheels / back up valve - are not driving as they should. Also hose / floats and tail due for service ($105 or less).

The Auto Fill manual valve is leaking during use, it could just use a simple flush or a rebuild ($250+).

Even though the pool light looks relatively new, it does appear to have light condensation present inside the light lens between 10 to 25% - therefore recommend update with a new light can ($200-1250+) + labor install $400

Filter is functioning leak free however the pressure gauge is bad $50 and likely the elements are due to be serviced $150 or more likely the elements are due for updating and or replacement ($400+).

Filter pump is less than eight years old, does appear to be due for a pump lid o ring and basket service ($50 or less) and ideally for safety a bonding wire attached ($100 or less) otherwise in ideal working condition.

Older no longer functioning Gas Line is turned off, it appears to be closer to a 200,000 BTU heater, recommend removal ($500+) or for a light heater expect a cost of between 2000 to 4000 + install labor ($1k+) but first check the Gas Line to make sure it is able to support a heater / gas draw.

There are two timers installed both timers function, the filter pump, and the booster pump, both are independent, yellow dial timers, they are not interconnected, they also are not 100% secure from falling / supporting weight - recommend safety update = which should include adding GFCI breaker to variable speed pump and pool light ($400 parts and $300 electrical labor) + support $300 or less.

The equipment pad has a lot of original copper plumbing, there does not appear to be any leaks present, but the Plumbing can be updated, if desired ($1k or less). This would include repainting and relabeling, as well as hard plumbing for the booster pump.