One obvious rebar issue and a separate likely rebar blemishes present, one below light can, the other near the bottom, likely both of these areas will require repair ($1k +/- each ?).

Note the correct way to repair rebar is to completely cut out and update the affected area between 6 inches up to 18 inches overlapping rebar (best way).

Also there are missing surfaces present, one seen in the shallow end, indicating the surface is likely on the last 10-25% of its life cycle. Recommend a minor patch ($10) ideally in this pit location, to help minimize water loss at this spot - when applicable.

Additionally, the surface appears to be older than 15 to 25 years - and may be nearing expiration - the cost to re-Plaster a pool This size would be between 8 to 12,000.

Some mortar wear, mostly seen at skimmer connection ($500-1k) / corners and the waterfall is due for re water proofing ($1k+)

Higher chlorine, lower pH, and alkalinity, lowers CYA, but nominal calcium hardness, water loss not obvious - but low CYA is one sign of water loss. Recommend re checking in 1-30 days to help confirm.

Balance chemical $100 or less to help confirm.

The skimmer needs a new float / float o ring / weighted basket / lid ($300 or less).

Main drain covers may be older than 7 years, if so, recommend updating the covers ($100 or less x 2).

Cleaner needs minor attn / tuned down / tail / tires soon

Could not open the canister, could not check the float. Appears set slightly too high. Recommend checking and servicing.

Condensation present inside the light lens, a like light is $1050+ labor to install $400

Additionally the micro light is failed and due to be updated $600+ +labor $400.

Working. Leaking from top union, and pressure gauge not functioning ? ($50) / filter is likely due for quarterly service ($150+) and then confirm element status - if elements are older than 18-24 months may be due for replacement ($600+) which I feel is likely due to lack of maintenance on pressure gauge.

Working, not leaking at this time. No major issues seen.

Working without issue. Sun exposed, but ideal.

Board is in working condition. No issues with its function.

Safety Update would include getting up to GFCI on the main breaker to lights ($100 or less + electrician $300) otherwise it’s nice to see the correct variable speed breaker present , and GFCI plug / outlet.

Again not required just a formality to bring it to full GFCI

Solar is automated and actuator is functioning.

Equipment pad appears to be recently updated / serviced. No major leaks present.

Recommend covering from uv using a uv mesh ($50) as well as re painting and labeling the pad ($100).