The surface overall has minimal wear present, somewhere is seen in the deep end, bottom and in some areas throughout the shallow area, but overall ideal.

There are two areas of blemishes,

The first is on the deep end wall it appears to be an obvious rebar stain issue, this will likely require a repair in the ballpark of 1 to 3000 depending on depth of issue.

The second is in the deep end, bottom area, where there are many small rebar colored stains that likely are surface only, but should still be tested to confirm, using stain treatment treatments ($400 or less) to attempt to remove the stains to confirm if they are surface only.

Otherwise, the remaining Plaster would likely last another 15 to 25 years additional.

Heavy calcium buildup present, $655 or less to remove.

Skimmer throat connection is ideal.

Low chlorine, high pH and alkalinity relatively low CYA and normal to high calcium hardness.

Recommend adjustments, likely water loss is not present, and organic matter is growing, due to be treated ($300 or less)

Recommend float O-rings x 2 , and floats ($100 or less) otherwise working well at this time.

The two main drain cover aqua star 10 inch, are due to be updated for safety due the agent and condition ($200x2).

This unit is due for minor updates, including a new tail adjustments to the hose, which may include adding one or two hose swivels ($105 or less)

Also note that the cleaner unit itself is way overpowered, and the wall adapter could likely be adjusted to allow for a slower movement on the bottom cleaner, which is currently set to about 200% power.

The auto fill is running continuously, indicating that the float itself is having issue or water loss may be present / evaporation.

Recommend service to the auto fill canister to clean it out and service the float head and also check canister more thoroughly along with servicing the manual shut off valve ($125-250 or less).

Condensation present inside the light lens, recommend updating the light can for safety.

A new light light is approximately $1250 +
Labor $400

The filter is likely due for Minor service to the tank O-ring (leaking) for less than $50, but it is likely that the elements inside the filter are newer, and not due for a cleaning at this time

Also recommend a new liquid filled pressure gauge at around $50.

The motor is failing on this obsolete Pump, the repair repairs to this pump will likely exceed the cost of a near New Pump.

A like Pump would be the Pentair I3 3 hp, at a cost of around $1900 plus around $800 to install.

Versus repairing this pump, a motor sourced if possible maybe around $1200 plus labor being around $800, that’s assuming everything else is in working condition.

The pump is working, however when I arrive, the breaker was tripped, it also appears that there is a leak from the intake, which may potentially be a split in the plastic housing, recommend service to confirm ($150 or less) - worst case if the pump has failed that it’s suction point connection which I feel is likely

New Boost Rite = $700 + install $700

The panel is due to have its temperature sensor updated, and likely its plug breaker updated for safety ($200 or less).

Recommend covering from the sun using a uv mesh asap ($50+).