Recommend attention / correction, heavy wear present. This surface is a proprietary mix of gunite and waterproofing that is showing signs of being on the last portion of its life cycle and in need of immediate waterproofing (most noticeably needed on the raised wall / waterfall vs main pool being likely more remaining life left).

There are essentially two waterfall extensions / water runnels - that appear to have active water loss seen literally through them and will likely need waterproofing now.

I do see this water loss coming through the gunite itself in several locations, and cracking is present throughout the raised waterfall and some of the pool decking area.

It is difficult to determine the full extent of the gunite rock Re-work & Re-waterproofing is likely needed now rather than later (estimated cost TBD).

This is a natural-design pool, so they should be able to provide a bid.

But a general construction estimate will be 10-15k for re surfacing in the pool, and raised wall will also likely cost 10-15k as well depending on methods used.

Water loss is seen throughout this surface during water fall function, which over fills the pool and in turn looses water on its south west border = design flaw likely, can be mitigated by fill adjustments.

Recommend less than $375 in algae treatments and corrections.

The covers do not appear very old but could be older than 7 years. Recommend updating for safety if older ($200 or less each) x3

Skimmer function could not be fully checked due to high water level.

Recommend a new float , float o ring, lid , weighted basket ($300 or less)

No cleaner present. One can be added for approx $650 = Polaris 280/380

Recommend service to bring back to working condition / new float ($125-250 or less).

Condensation present, recommend an updated can ($200-1250) + labor $400 for safety.

Recommend attn to the pressure gauge ($50 liquid filled) and likely quarterly service to this filter soon ($150 or less).

Otherwise this filter appears functional, but this is my least favorite filter due to the mass amounts of service required compared to a sand filter.

No major issues. Recommend a new pump lid / o ring / basket ($200 or less)

Non working. A replacement pump is approx $350-600 + install $600 + hard plumbing $400 if desiring bottom cleaning.

Older. Sun exposed. Leaking from what I assume is its return union, recommend service to both return and suction unions to help confirm ($150+).

Otherwise older but working.

Older switch panel. Working. Plug outlet not working correctly.

Breakers due to be updated to GFCI for safety = variable speed breaker , light , and plug ($300 or less + electrician $200+).

There are 5 valves due to be serviced at minimum - o ring set ($150 or less each x 5) and maximum new internals ($200 or less x5).

Also new paint and labeling and uv mesh coverage $300 or less.