Access left hand side from street, behind propped open gate.

Without major issues seen, some cracks forming on the outter rim area, common with age, but no notable blemishes in the water area. Note 1/4 of the pool was covered during the inspection but only one unusual device? Seen on the east wall under the covers edge.

Note I am seeing the chlorine levels being very high potentially effecting the air inlets, and light fixtures / anything touching the pool due to salt conditions. Overall it would be wise to consider removing the salt conditions if possible to help prolong the life of all connected devices and equipment.

Ceramic over , fiberglass.

No issues seen.

Tile and skimmer was re sealed 4 years ago. Skimmer seal is in fair shape - may need attention in 1-5 years ($100+).

Algae seen + high chlorine = likely water treatments / water cycling may be wisest . Recommend adjustments ($200+).

Recommend cover updates as they are all older and due ($100x5).

The skimmer is due to have its weir, maybe new basket ($100).

A new light can is approx $500+ + install $400.

Note this light can may be compromised during service due to age of fiberglass shell.

Seemingly like new without issue.

Still recommend service to the element (due to higher pressure) likely element replacement ($200+). Otherwise without issue.

Older, rattling bearings, when arrived breaker was tripped. Likely a nearly dead pump. Recommend replacement motor ($1-2k+) or new pump ($3-5k+).

This is a small simple pump and filter combo solution that is compact and ideal IF the water is blue and clear. Recommend service / new element on this filter ($200+) and minor service to the waterfall basin ($350).

Recommend service

1. ORP low = however currently high Chlorine and Dosing 🙁

2. PH high yet set to ok = also dosing while on site ...

Recommend service ($205+) asap or turning off to avoid issues.

Newer - In Good Condition - but this blowers mounting is corroded at its base where its connected into the ground - not urgent but due soon / recommend attention / also should be bonded for safety ($200+) otherwise working like new unit.

Heater is Newer, working, gas line is due for minor attention / paint ($100) and check for leaks ($100+) at gas connection-due to age and condition.

Panel is like new. New GFCI breakers and GFCI plugs. Ideal. But the panel is not mounted appropriately to the ground, wobbly, dangerous = recommend attention asap via electrician ($300+).

Seemingly working , all green and over chlorine. Recommend service to cell as required every 3 months ($100+).

Also note that someone has cut the side of the cord, this should be repaired ($? - 450+) or hopefully covered under warranty now vs later (3 year max).

Recommend quarterly cell service ($75+) soon.

There is a lot of moisture on the pool equipment pad - seemingly coming from one or two locations, one is around the filter, the other around the west side closest to the pool valves. Much of this Valving has been updated, but I am seeing the blue glue on most of the older plumbing closest to the wall that is likely due for updating soon / due to water loss and condition ($1-2k). Salt conditions are also accelerating inherent issue here. Especially considering there is a stainless steel manifold system being routed underneath the pool / spool shell.