Of issue. Recommend re surfacing + repair shortly.

The surface doesn’t look very old - to me 7-15 years old. Still it has check cracking present and scratches as well as one large rebar stain, indicating that re surfacing will be due soon. Approx cost to re surface ($10-14k+) and repairs to rebar stain , new pool light niche if needed, new skimmer, and new auto fill, expect a cost of at least $4k+ extra on top.

Note that any surface movement (which we saw movement that seems to be 1/2” in the north east side lower than the west side) may require additional measures to properly level / re pair / replace shell.

Some concrete movement seen on the north and south side of pool. No visible additional signs of issue inside the pool, just the coping and concrete.

Recommend grinding / leveling / re adhering and mortaring coping / jacking $1k+ to prevent trip / injury hazards 1k+ + mastic fill $1k+

And the sconces on the walls of the lions heads are due to be re attached ($500+).

Also the skimmer is sounding hollow indicating movement exists in this area.

Water is very very out of balance and will likely require a 1/2 or more drain and re fill ($300+) and re balance ($300+).

Also recommend re testing water loss status when chemistry is more aligned, current results are likely flawed.

Main drain covers are due to be updated. There are four in the pool. $100 x4.

The skimmer is due to have its basket, float , float o ring, lid, and weir door updated ($400+).

Note the skimmer is older, and has significant chlorine wear, that with movement this would be wise to update at time of re plaster.

Unit is due for some attention ($205+) new lower body soon, bag, hose segments maybe tail + weight soon

A crack is seen on the fitting into the wall, this is a tricky fitting to address if water loss develops ($125+). Mp lid due for replacement as well.

Near new. But does not turn on via light switch. I reset all breakers and still found it not being able to turn on. It dead a new like light can is $900+ and $400 labor.

The filter is heavily sun, damaged, and in overall poor damaged condition, recommend a new pressure assembly, gauge and service ($200+)

Without issue.

Upon arrival I found this lump working, but I am unable to get this to turn back on manually / Showing signs of issue / rotten seal plate. Recommend update ($500+ pump + labor ($400).

Working without issue. Near new.

The panel has been updated some. Recommend updating the lights breaker and plug to GFCI ($100-300+).

Also it does not appear we have consistent timer function if that’s the case recommend updating the timer / adding a relay to the filter pump ($300+)