Without issue. Approx 12-48 months old. No major signs of issue.

All waterline tile appears to be in like new condition with very little calcium buildup present in between some of the tile tiles.

The natural rock border the raised wall also appeared to be non-loose condition without much of a gap present. There was only one loose rock at the top of the north rock area.

On the waterfall, it appears that they did trim the lip very close which will accumulate more calcium as a result. Therefore, recommend running the water waterfall minimally to avoid excess wear / calcium.

Cya is too high, recommend adjustments / partial drain to re balance ($100+).

Also algae is present recommend treatments ($150+)

Main drain appear VGBA compliant.

Skimmer in my opinion could use a skimmer float + o ring ($50). Otherwise ideal.

The bottom cleaner right side appears to not be functioning, and so it is stuck in place (hence why there is leaf debris present on bottom of pool) I would recommend turning off the bottom cleaner until it is repaired to avoid damage. And I may be wrong, but I am almost certain this unit has a back valve… if so +$105. Otherwise service to this unit is likely $100.

Ideal, recommend minor clean out of fill canister ($20).

The north most light appears to be out of sync (easily fixed with simple programming) but the light itself appears to have some condensation inside the lens (which can be seen the easiest when RED is illuminated). This light will likely need to be replaced in 1-12 months ($650) + install $400.

The filter pressure is very high. If it is just a error with the pressure gauge ($50) if not a bad gauge this is indicating that the filter elements are dirty, and overdue to be cleaned ($150) but I suspect the elements themselves are likely due to be replaced ($500) which the seller mentioned he would be doing right away. To bring this pressure down to 5-15 (more ideal).

Without issue.

Working without issue. The hoses are due to be serviced / replaced soon 1-5 years ($200) or I would recommend a hard plumb instead for 30+ years ($500).

The panel was in ideal working condition. Without issue. GFCI present pump + plug

The pool equipment pad is all in leak free condition. The only issue I can see is that it is heavily sun uv exposed. I would recommend repainting and re-labeling this pad ($200) and covering from UV using at least a UV mesh ($50).