The east access fencing is in working condition at this time, it is likely tension a little too tightly, and should be modified slightly, and the mount latch should be better fixed to the wall of the home for longevity.

The surface all appears to be in ideal condition no cracks or major blemishes present. Approx 12-48 months old.

The waterline tile all appears to be in ideal condition overall, the only areas of concern I have are in the north west corner in south east corners, both appear to have a massive buildup of water fleas ? And for whatever reason they are attracted to these areas, might be due to water loss ? Minimal chance but notable to confirm ($10).

Otherwise, what is seen is tile and wall tile in good condition overall, minimal mortar joints but consistent (likely due to design).

Minimal calcium build up - can be removed likely via pumice stone.

There are tons of thousands of waterborne bugs, recommend treatments to remove ($300+). Maybe wise to consider purging the lines and draining and refilling The Pool ($650+) but first low cost water treatments to resolve, also trimming back and treating the foliage around the pool.

The main drain and the skimmer are both in ideal working condition.

It still would be wise to consider installing a skimmer float ($100+) and opening up the main drain suction.

The bottom cleaner installed is likely less than one to three years old and in relatively good condition overall, we will need a new tail soon and the minor adjustment to the hose and hose swivel ($105 or less).

The auto fill float area will need to be cleaned by simply over filling this area with a hose on the return port ($20).

The polite to me clearly has condensation present inside the light lens and should be updated for safety with likely a new light can ($500+ install $400).

The filter shows a slightly higher pressure + the amount of water borne bugs present it would likely be required for the elements to get replaced ($500+) once water treatments to The Pool are complete, along with a standard servicing of the tank O-ring set ($200+).

This pump is in working condition. Recommend minor service to the pump lid O-ring, suction side union and return side union soon ($100).

It does appear that the board and timer are in working at condition without issue at this time all aspects function and GFCI breakers are present.

For an unknown reason, the breaker to the filter pump was turned off upon arrival, after turning it on and testing all functions, I am not seeing any obvious reasons why that was the case. Still I will leave off the breaker upon departure.

All valving is in working condition, no leaks present.

Soon (1-5 years) though the equipment pad should be repainted and re-labeled and likely the check valve updated and the chlorinator serviced ($700+)