Coping needs to be replaced above the skimmer , at the same time as fixing the leaking skimmer. The finish will need to be redone by a moson, concrete guy. The estimated cost to redo the finish of the ground for both the auto fill and skimmer, is 7500-10,000, to match to stone right for a good look.

– Skimmer Canister Leak ($5,500)

Issue Identified:
The skimmer canister is split along the side wall, creating a large structural break. Dye testing confirmed active water loss through this crack.

Temporary Action Taken:
A temporary epoxy patch was applied to stop water loss for testing purposes.

Recommendation & Cost:
The skimmer canister requires permanent structural repair or replacement to resolve the split and prevent further water loss.

Estimated Cost of Repair: $5,500

– Autofill Canister Leak ($6,500)

Issue Identified:
The autofill canister has a severe leak at the outlet pipe. The pipe has sheared away from the glue joint at the bottom of the canister, creating a large opening. During inspection, the leak was actively pulling in leaves and debris. A hydrostatic test confirmed that the canister drained completely in just over one minute.

Temporary Action Taken:
The outlet pipe was plugged for testing purposes, which confirmed no further water loss once isolated.

Recommendation & Cost:
The autofill canister requires a permanent replacement/repair of the outlet pipe connection to restore full function and eliminate the leak.

Estimated Cost of Repair: $6,500

Heater not working at time of inspection, due to age and rat infestatiotions replacement will be the way to go in this situation. Cost is estimated at 5,000.

Needs a new jandy on the wall pool controller inside, estimated cost is 1850 installed