Blemishes present on

1. Deep end step wall
2. On deep end wall south east
3. On deep end wall north west
4. Shallow end east wall to shallow ends.
5. Shallow end north west bottom to waterfall bottom (rust present) recommend attention to remove / confirm if of issue ($400).

The waterline tile and rock work has significant calcium buildup present. It is likely at a cost of approximately $1500 to properly remove the calcium from these.

The waterline where it meets the rock will eventually need to be re mortared, which is likely soon (1-48 months) ($2k+) at the same time the rock waterfall ($2k+)

On the flat concrete between the house and pool, there is raised concrete due for grinding for safety ($500-1k+)

The main drain itself is not compliant, and all three covers should be updated for safety ($88x3).

The skimmer has signs of chlorine abuse present.

Additionally, recommend updating the weir it does appear that the weir door is older, and it is missing it’s float recommend updating the float O-ring and the appropriate sized weighted basket along with a new skimmer lid ($500).

The skimmer itself has blemishes presence on the southwest side of it. It appears it might have some minor cracking and will require some attention to re-waterproof soon if applicable, and there does appear to be an auto drain, which I am unsure if it is working, I would highly doubt it is not, and should be plugged as well ($200).

This unit is working, but it is older and showing signs of issue as it is getting stuck in one or two locations and not moving from them. Instead of updating this unit due to its high cost and proprietary issues. I recommend a far better and far superior cleaner, “the pool cleaner four wheel” at approx $500 + in line basket ($150).

For an unknown reason it appears they have put the two pieces together likely to prevent water loss still it does appear that this auto fill canister is in working condition at this time. The fill however does enjoy being stuck on when it’s should not be recommend service to resolve ($125-250+).

There are three normal sized pool lights installed. It appears that all three have water present inside the light lens. Each light can is approximately $600 x 3 + install $700. And one small spa sized light ($550) + install $350

The filter pressure gauge is faulty and not working correctly. The filter elements are likely due for service ($150) to confirm if the elements are due for replacement ($600) which they likely are if I had to guess.

The filter pump is working currently however the display is no longer functioning correctly (or during hot weather), making it likely impossible to program. It also appears to have moisture present under the seal plate likely due to an issue with the plastic molding. Since This pump is obsolete, therefore it is likely replacement will be required ($1500-2800).

The waterfall pump is buzzing, indicating it is likely expired, approximate cost to replace with a like model pump ($750-2800

For an unknown reason, the panel has a breaker that is not in use = 50 amp.

It is due to have its variable speed breakers updated as well as the pool light to GFCI ($300+). Also recommend adding a water bond ($300) for safety.

The salt system is no longer being used which is ideal, recommend removing the salt cell via removal ($300) or replacement would run $800-2500+

This equipment pad is in direct sunlight all day long. It would be wise to consider painting the plumbing, re-labeling, and putting a UV mesh over the entire pad to prolong its life ($400). There’s also ABS installed, which should not be present recommend updating ($400).