Surface appears to be over 20 years old. There is where present seen, especially in the deep end and some of the shallow, this may just be modeling occurring due to salt conditions. When seen in the deep end rest colored, likely only surface level. I am seeing Plaster wear around the step tiles. Overall, the surface appears to have likely less than 1 to 10 years of life remaining before replaster may be come required ($7-10k+).

The tiles leading into the skimmer throat are due for some new mortar as well as around the skimmer throat, all have been patched and should be updated for water proofing ($500-1k+)

I do see signs of water ingress on the Waterfall wall. Detailed more on Valves section 2

Water quality is indicating that the chlorine levels are high as well as the pH and alkalinity levels, the CYA and calcium hardness levels are ideal. I would only do minor adjustments to the high levels ($40).

There are two main drain covers in the pool that are due to be updated ($88x2) as well as one equalizer line that may have been updated recently, if not recommended replacement ($88).

The skimmer has all the appropriate parts, but it may be wise to consider updating the lid, float, and float O-ring ($200) soon.

The bottom cleaner is working one of its tires is due for updating its tail as well and likely its hose shorten some … ($205+).

Could not access fill canister. Otherwise no leaks seen at fill valve.

+ install $400.

Recommend service ($150) then likely elements will be needed soon ($500). Plus the band is starting to fail ($200).

This pump is fairly new and without issue at this time I would recommend though programming ($50) this motor to run at much less max speed it is currently over set.

Booster pump is working, but it is vibrating fairly heavy and sounding relatively distressed. It would be wise to likely plan for a replacement soon in the next 1 to 48 months which likely will run approximately $1500 installed that will include hard plumbing versus the soft hoses.

This is a high-quality heater and it well maintained i.e. adding a heater bypass, should last more than 10 to 20 more years.

Working without issue at this time.

You lower subpanel some of the switches appear to be off centered and breakers. Recommend minor attention to resolve these issues ($150).

The sub panel box is rusty from the inside from being left open to the elements.

In salt system display appears to be partially working, and the salt cell does not appear to be too old in running hours vs age of unit. Still, it does appear to be in working condition at this time.

Involving and plumbing is due to be painted and re-labeled ($300). Additionally, I would recommend updating the booster pump hoses (as defined in booster pump section).

Would also be wise to consider adding a heater bypass to prolong the life of the heater, especially in salt conditions ($800+).