The surface is older and fairly worn. There is also a blemish in the deep end main drain area that extends almost the entire bottom of the pool. This crack is likely structural and will require seperate repair ($5k+) at time of re plaster stage ($8-12k) which appears to be nearly now.

Surface appears to be older than 15 years old.

The waterline tile appears to be older, and then one section loose (corners) and missing (north east ) therefore recommend special attention to confirm if Tile is due to be re mortared ($500 repair of what’s seen - 2k+ re-mortar service complete ).

I do see active water loss being present at the pool filter / equipment pad.

Additionally, the chemistry is indicating we have waterloss present (low cya / cal).

Also, we do have black algae presence throughout the pool, which will require special attention to possibly remove ($375+).

The main drain cover is a single cover. It is Older and due for updating ($88+) for safety.

The skimmer basket is stuck inside the skimmer; could not check skimmer bottom.

Likely due for a float, float o ring, weir door and weighted basket ($400). Older skimmer blemishes present.

The bottom cleaner installed is relatively newer, approximately 1 to 3 years old. But non working ; internal bands broken, tail has a hole, likely more issues present. Approx cost to bring back to working ($200+).

Manual fill present. Leaking during use. Recommend update

The pool light present is actually a spa sized light. It was unable to get it to turn on, but it does have water present inside the light lens. Replacement cost is $700 can + install $400.

The filter is operational. It does have a small leak at the tank O-ring ($50) additionally, the filter element due to the black algae being present, but likely need replacement after service ($200+).

The filter pump is poorly in operational condition at this time, but it is leaking out of its return fitting, which will require service to confirm issue is just there only ($125+). The motor is damaged via corrosion due to prolonged water exposure. The motor cost to replace is $750+ when failure happens.

Note, I am not very impressed overall with this pump and its longevity. A better pump would be a super flow VS at $1100 for example on costs.

This pump is working, but it is leaking from its hose to PVC connection @ $10-200+ to repair, this will include the loose conduit connection.

The timers are newer, and the box it’s in is older and heavily water damaged. The breakers are due to be updated for safety compliance = GFCI @ approx $300+

The timer covers are missing their plastic protective covers ($50).

Recommend painting , labeling , and covering from uv ($200+).