For an unknown reason, the plaster above the pool light has heavy pressure blasting markings present, these areas likely will have to be filled in with some temporary repair ($100+). Around the returns I am also seeing heavy. Wear likely missing Plaster to the gunite, these areas will likely need temp repair ($100x2). Note that the surface has many abnormal blemishes present, including small check cracks seen mostly on the bottom and the steps, and if the temporary repairs are performed, it is possible that the surface has some potential remaining life present (1-48 months). Again, we are seeing rust colored stains in the shallow end and in the deep end, possibly rebar issues and if so, expect a cost of + $1-2k to repair during the re plaster stage (worst case).

Otherwise, a re-plastering of this pool would be wise to consider as it is likely the best value ($8-12k+).

The waterline tile is in fair condition overall. There is calcium buildup on at least 3/4 of the tiles that can be removed with service ($600+).

Do you want a chemistry isn’t leaning me towards thinking that water loss is present except I am seeing water loss currently present at The Pool equipment pad from the pump and other various pieces. Recommend recheck in one to 30 days to confirm.

There is algae present in this pool that will need to be treated for approximately 200 to 350 to properly eliminate this includes cleaning the filter elements x2.

The main drain covers are due to be updated for safety ($200+) due to age and condition.

The skimmer has a 3” chlorine cookie inside of it, this is not ideal and does cause damage. The skimmer has one unusual mark on the back of the skimmer, and blemishes seen on the water line.

Recommend a new float , float o ring, weighted basket ($200).

This is a low cost hundred dollar bottom cleaner that is working at this time, a better unit or as I would classify it in an A+ unit, is “the pool cleaner four wheel” with an in-line leaf basket Pentair , at approx $600 when this cleaner expires.

The auto fill float appears to be broken and running continuously. Recommend attention to resolve ($125-250).

The pool light is working, to me it appears that the lightbulb was replaced with an LED bulb in an older can, and therefore may only last for one to 24 months before replacement ($700 new can + install $400) will be required. Recommend cleaning this light can on the lens which is appears to be dirty as well as behind the can in the niche ($100) to verify its actual status.

This filter is older and heavily sun damaged. It is leaking from its tank seal ($125+) and does appear to be due for filter service ($125) to confirm if the elements are due for replacement ($400). No, the pressure gauge also may be faulty ($50). Vs a new filter $750-2800+.

This pump is an older Northstar pump that does appear to be leaking from its pump lid And not fully being able to prime. I would classify this pump as overall in poor working condition. It is likely that this pump will need a new pump Lito ring basket and if leaking at it, seal plate, the seal plate and shaft seal ($500+). And this Motor is very very old and may be due for a new replacement motor in the next 1 to 24 months ($750-1500). Vs a new pump $750-2800.

The timer is in working condition. The Pool light switch is also in working condition. The breakers to the pump and light receptacle are due to be updated for safety compliance ($300) and also consider adding a water bond ($300).

The salt system is in damaged addition likely the panel and the salt cell are both due for replacement ($2250+). The display is not working and the indicator lights indicate the salt cell is no longer functioning.

The Valving present is due for updates, including the solar shut off and the check valve as well as the three-way valve for the solar and the leaking check valve after the pump ($1500+). As well as repainting and re-labeling this equipment pad ($300). And also considering removing the salt system / solar, if no longer being used.