We have a painted and primed surface that is pitting and losing sections, mostly in the deep end and some sections in the shallow and likely mostly from wear. I feel the surface is in expiration and should be planned to be removed ($1000+) And the surface resurfaced if the surface is in fact compromised ($10k+).

The waterline tile has significant calcium buildup present, and the water stop is missing from some of the pool. To remove the calcium expect to pay approximately $500+.

On the south side of the pool, the concrete is lifting and raising likely from underground roots to redo this area expect to pay between $1000-$3000+, which would include excavating the existing roots.

Noticeable difference in pool water level from north to south side of pool, 1/4” - 1/2” approx. This is nearly out of spec and can cause underground piping issue.

Some small sections of missing tile that can be repaired for approximately $500-1k+

Recommend balancing the water chemistry, approx $100-200.

Older skimmer, working. Recommend skimmer float valve and o ring ($50) and a new lid soon ($50).

The main drain is not safe and should be updated asap ()100+).

Slightly working. Likely due for service to swivels, tail, backup valve ($205+).

Working.

The pool light has water condensation inside the light lens recommend updating for safety ($575 can + 400 install).

Working. Not leaking. But poor quality and sun damaged. Plus the filter is audibly bubbling over internally showing signs of impacted elements, which will also be caused by the pool having a painted surface. Recommend replacement elements after surface refinishing ($400+). I also would not recommend putting too much money into this filter versus buying a new filter at roughly the same price as this filter is generally low-quality.

This pump is working without issue there is issues seen at the return fitting leaking ($400) and this may just simply be dripping down under the return union, but still recommend service ($125+) to the union to confirm.

Ideal condition sub panel , still recommend updating to GFCI breakers and new GFCI plug outlet ($300+).

The bracing for the timer has rotted out and will need to be reinforced for safety can simply mount to wall ($200+).

Recommend painting and labeling the equipment pad to protect it from UV. Also, there is a suction side section of blue glue plumbing. It may be wise to remove that and install a check valve instead and remove and install a new coupler on the return side if you want to get extra picky ($750+).