The surface is near new and only showing some wear (browning) in corners of deep end and steps.

The waterline tile appears to be ceramic and glass etched.

The only area I see of concern is the most northwest corner where some of the tiles may be slightly lifted, if of issue expect a cost of $100+.

Recommend adjusting the CYA level and calcium hardness level. Water loss status due to zero cya level. Recommend balance ($100) and rechecking in 1-30 years

The main drain cover has recently been updated. There appears to be one hole present below the center of the cover, may be VGBA compliant, recommend closer inspection.

The skimmer throat is an ideal working condition. Skimmer basket, float, and weir door are all present.

The skimmer is older and has some chlorine wear present. Also there appears to be a puncture that will need to be fixed / plugged ($100) asap.

Working without issue. It does operate without the filter pump running. The unit appears to have slightly loose wheels likely due to gearing present nearing due for service ($200+) likely the cause for the unit to get stuck in 1 spot and stop.

The fill is leaking during use, recommend repair ($125-250+)

420 Sqft cartridge filter in working condition. Recommend minor service to filter elements ($125+) otherwise without issue at this time.

Recommend minor service to the pump lid O-ring ($50), I am seeing very light bubbles presents inside the pump basket. Whom ever installed the pump did not account for the need to open the display and therefore it is difficult to conduct standard programming as a result. Also recommend attaching the conduit correctly to the bottom of the pump ($200+)

This pump appears to be leaking from its return hose connection. Recommend service to resolve ($100+).

I cannot access the right timer, which controls our to the filter pump, Which may be not a large issue since that pump has its own built-in timer. But the conduit has come disconnected from the timer itself, therefore recommend minor service to resolve ($100). Also recommend adding the protective plastic piece to prevent shock ($100).

Additionally, it does not appear that we have GFCI for the pump and breaker updating for safety ($250+).

Equipment pad has many blue glue connections, including on the pump return these connections will likely need to be redone in the next one to 10 years ($1200+). In general, if you consider painting and labeling to protect it from UV ($200+).