Fencing not present. Cost to install mesh fencing expect a cost of $1500+

The current fencing to the backyard is non self closing self latching. Recommend repair for safety ($125+).

The surface has wear present on the corners of the steps and the bottoms of the floor of the pool. There’s also scratches present and tiny pits present throughout. The surface appears to be between 7 and 15 years old. Under the equalizer port, there is a blemish present that appeared initially to be a crack, but may only be an abnormality. There are also a few calcium fishers present. The area of the waterfall step has significant blemishes present, As well as the shallow end first step deepest. If these steps begin to delaminate in one to five years, expect a cost of 3 to 5000 to repair vs the entire Pool replastered would likely run between $8 and 12 thousand.

The concrete decking in the north east of the pool, has settled considerable, and may be compromising the skimmer if not now, soon and would require leveling ($1500+) or replacement concrete ($3500+) to resolve.

The waterline tile has calcium build up present, and the waterline tile are older, due for calcium removal soon ($550+).

The waterfall is due to be re mortared soon ($1000+) to prevent waterloss during use.

New water and or water losses present recommend balancing asap ($200+).

There are two older covers in the main drain and one on the skimmer equalizer that are all due to be updated for safety due to age and condition ($300).

The skimmer is due to have its float, float O-ring, skimmer lid updated ($300). The skimmer was installed in 2003,

The bottom cleaner is due for service likely a new hose tail and swivels ($205+).

The auto fill is in working condition. Recommend a minor clean out of the auto fill canister ($20).

Water inside the light lens, recommend replacement can ($575) for safety + install ($400)

Leaking during use at tank o ring + tank appears older / no longer working.

To update this existing filter with new parts expect a cost of $800-1200 to include elements, a new base, band, o rings, pressure gauge, and possibly a top or bottom. Vs a replacment filter new at the same cost = is a far better value.

Filter pump is in working condition however it is a high energy consumer and not title 20 compliant. A compliant pump would be a two speed / variable speed pump at $750-2800+. This pump is working at this time with older bearings. This pump appears to be leaking from its seal plate and possible shaft seal as well as pump lid = Indicating that repairs to bring this pump back to working condition would range $450-950+. Recommend attention.

The timer is functional. To update the breakers to 2025 standard expect a cost of $350-750 to have an electrician install variable speed ready GFCI breakers, and GFCI receptacles.

The solar controller appears to be in working condition without issue. It does function the actuator and shows an indicator light that the solar sensor is due for updating. A new solar sensor installed is likely $350 And it appears the solar may be leaking at this time / equalizer air purge is due for service ($350).

The equipment pad is heavily sun / chlorine abused, and will likely need to be modified ASAP to bring back to working condition. This will include removing un needed / older check valves + unions, Modifying the energy bowl to the other side of the filter, updating solar valving to higher quality two way valves, repainting and labeling equipment pad ($1500+) vs service ($500-750) to current equipment (which I do not feel will solve all the issues that repalcement would.