There is a blemish in the west end of the pool clear indicator of structure compromise. Cost TBD. via Pool Remodel Contractor - estimated construction value to remedy the situation $15-50k. This would likely include the cost of a new surface for the pool complete.

Currently with these cracks and not knowing the extend of damage - the remedy would include the cost to resurface - resurface estimate cost is 9-15k.

Note the cause of cracking present appears to may be due to settling of sub surface - concrete around pool is settling un evenly and on the portion closest to the lake is settling down towards it, leaving cracks on the concrete path and lifted trip hazard pieces that will need to be grinded down for safety before needing to be repaired. Estimated normally in Tile Section but should be detailed here due to issue present noticed in surface.

East most concrete is lifted. West most concrete is settled down.

Blemish / Cracks / acid wash burns / on surface seen in shallow need and edges of north middle.

New mastic. Skimmer throat hard to see, due to water level, tile appears original. Minimal calcium.

Lifted concrete, recommend grinding edges down for safety ($500-1000+).

Recommend balancing chemicals ($200) and retesting to verify water loss status.

The main drain covers are due to be updated due to age and condition ($100 x 2).

The in floor heads are likely due to be updated ($200+).

The skimmer is due for a new weighted basket ($50).

Working but nearing maintenance ; new treads. Older unit. Chlorine Chemical stains present. Unit does stay in one section of the pool for prolonged periods of time. May be nearing failure point ($750-1250).

The auto fill is likely set slightly high ($20), skimmer level currently to the limit for opening (throat).

It appears both lights function but may be replaced with a low quality bulb - older light can - both lights have to “heat up” to function. May be indicating failure soon. Each light cost is $500 x 2 + install $350 each x 2. East light appears to be slightly loose - recommend checking and verifying connection / mounting. Algae present around light.

Recommend service ($205) to confirm if new elements are needed ($450) + pressure gauge ($40).

This older / original pump is due to have its return connection re sealed $150-450.

Note that it may be a wise time to consider updating the motor at least or the entire pump soon ($1000-2800).

Booster was running with no flow when I arrived. It’s likely this was done for some time and may have compromised the pump seal (not currently leaking during use). Still a new variable motor is $1200 installed vs a new pump $1200-2800. Recommend minor lid o ring and basket ($50). Otherwise working condition. Found on. Recommend service to solar system / testing when dry ($150+).

Breakers are due to be updated, for safety to comply with variable speed pumps ($400+). Otherwise recommend updating the plug GFCI ($50).

Non working. To replace expect a cost $900-2500.

Recommend a complete service here likely including removing some older equipment , re painting and labeling , and replacing old check valves ($1000+).

Otherwise leaking only at 1 chlorinator bypass, return connection on filter pump, and a leaking old o zone connection 1” or 3/4 plug.