The surface of the pool is older than 25 years and pits are present found mostly in the shallow end. There is staining present throughout and the steps have wear on the corners.

I would estimate this surface to last another 1 to 10 years before replastering ($8-12k) is required if not sooner due to autofill running constantly.

There are missing mortar sections beginning to develop between the tiles.

Estimated cost to re tile the pool $1500-2500+

There are gaps present in the skimmer and signs of previous “band aid” type repairs. I would estimate this to be a $500-1500+ job for a tile person to re-set the skimmer throat.

Significant calcium build up present at $750 to remove

The water chemistry is indicating that water loss is likely present at 150 ppm of cal hardness and less than 20-40 on cya. Additionally, the auto fill has been running continuously during the duration of the inspection. I would estimate approximately $100 to realign the pool chemistry which would allow you to also test for water loss again in 1 - 30 days.

Expect a cost of at least $300 - 2k to help accomplish a VGBA compliant main drain at time of re surfacing.

In the mean time for safety expect a cost of $100 for an ideal cover.

The skimmer is due for a correct sized basket, float, float o ring, weir door updating ($500).

The bottom cleaner itself appears to be less than three-five years old while the hose floats / pieces appeared to be much older, and the hose itself appears to be not too old. Overall, the cleaner unit barely works, and it will need some major service and new tires as well as a new tail soon ($600+). Recommend replacement vs repair.

Recommend service to the float and connection ($125-250) as the float is older and nearly dead and the can may need to be cleaned and verified no water loss is present by shutting off the flow of water to the can / fill and seeing if the water level goes down.

The pool light junction box appears to be less than 25 feet away from the pool light located next to the pool equipment pad. The pool light itself does not appear to be that old likely less than 5 to 10 years old, Still, the lens is showing water inside the lens, therefore recommend replacement ($565 can + install $350)

The filter itself appears to be older than 25 years. While the pool is very clear is indicating the elements inside the filter are likely less than five years old. I would still recommend service to confirm that fact, and if older recommend filter element replacement ($450) along with the service to all tank o rings and new gauge ($300). Note that a brand new filter would likely cost less than this, And would be my recommendation. Ie Aquastar 200 Single Cartridge

This motor is older and showing signs of heavy wear and usage. Additionally, the shaft seal appears to be leaking and or the pump seal plate, Expect the cost of approximately $200 up to $550 to repair this issue Along with a variable speed motor if desiring ideal for $750-1250+ vs a new high quality variable pump ($800-1250+).

Corroded motor body indicating failure in 1 - 24 months. The cost of a new like pump ($450+) + install $350.

Working dual timer box. With breakers due to be updated for safety ($125 variable speed breaker to GFCI, $25 for pool light breaker, and a new $35 GFCI for the outlet = approx $650 installed by electrician).

The Plumbing present is due to have its UV paint updated, And Plumbing relabeled ($300+). Ideally also install a check valve ($100) for the suction side of the pump.