The surface has scratches and staining present throughout as well as deep blemishes / scratches and check / cracking likely from chemical and poor chemical managment ,and appears to be 15+ years old but is only 3. Mottling present throughout. May have 1-7 years remaining without waterloss and re surfacing may be required in that time frame due to accelerated issues.

The tile all appears to be in ideal condition for age approximately 30+ years years old. The mastic is fresh and new. Could not check coping stone / tile fully due to mastic service being performed.

Chemical levels ie chlorine are VERY high and should be monitored.

Cover has old screws that are not stainless rusting out and will need to be replaced ($200).

Also the skimmer is missing its float and weir, recommend adding a weighted basket as well ($400).

The skimmer is older and hollow - and cracking present. Will need temp repair ($100) soon. At next remodel stage / replaster recommend a new skimmer ($1500-3500) installed.

The cleaner is working but needs a new tail , sponge, weight, and a trimming on the hose ($205+)

I did not find a fill line other than a potential fill at the hose bib connection near decking. A temporary fill is $125+

Pool light functions without issue. Switch is located in south west side of decking near pool.

Recommend service to filter and tank o ring ($150) as this unit is currently leaking. Otherwise like new and ideal condition overall and may need a new element ($200+) if pool went green several times.

Is pump is currently at its maximum pressure with a dirty filter element blocking its flow. This is the smaller half horsepower upgraded to 1.99 sf - And therefore is at its maximum flow / highest stress in this situation. Recommend filter attention asap to resolve issue with this pump.

Also note the pump needs its bonding wire attached ($50)

This pump is functioning but leaking from its seal plate, and hoses ($450+ repair which includes attaching bonding wire). Recommend repair or replacement ($1500+).

The panel is corroded and damaged from long term use. A new like panel would be $750+ installed. Also adding correct variable speed breakers ($300+). And a water bond ($300+).

Otherwise the panel is currently functioning and may for some time but due to corrosion is a danger and safety hazard.

The plumbing installed gives us one 2 inch suction and 2 inch and a half returns. Therefore we have more return flow than suction flow. Recommend hard plumbing for the booster pump ($500+) Repainting and labeling the Sikich equipment pad ($200).