The surface is missing in some areas down to the gunite. Accurate cost to re surface $10-15k depending on options.

There are one or two sections that are loose and will need repair + Note both skimmers will need service soon to resolve any issues of water loss in the throat / sides of skimmer opening ($1500+)

Some mastic will likely want to be applied to this pool to close the gap between the tile and the concrete ($1500+).

The concrete around the pool has trip hazards that are likely due to be resolved to avoid injury ($2-5k+).

The water quality is damaged with algae present. I would recommend approx $375+ in chemical to subdue the black algae present along with 2x filter cleaning.

There are two skimmers installed older than 40 years. There is no float need however the weir door on each should be updated, weighted baskets, and new lids X 6 ($500).

The main drain cover is not VGBA compliant and should be updated for safety ($100)

The bottom cleaner tail is worn, and whole right side drive train is non functional - recommend service to resolve ($205+).

The fill is in ideal working condition.

Pool light ($565+) + install ($405)

Normal to High Filter Pressure - Indicating a filter cleaning ($85) is necessary to identify filter element quality of life, if elements were recently cleaned this is indicating element replacement is needed in the next 1 - 24 months ($405-550) note that when the pool pump turned on for the first time, I did see debris come back out through the return back into the pool Indicating that the filter, elements and filter is likely not filtering correctly, and the elements are likely due for replacement which will be my recommendation. And worst case if multiple issue are present on this older than 20 yr old filter replacement will be recommended.

Also note that because there is black algae present in the pool. It would be wise to treat the pool first (detailed in Water Quality section) and then replace the filter elements.

Also note the tank o ring and pressure gauge will need service / replacement ($155).

Also note that a sand filter will be my recommendation of upgrade option due to the size of the pool and the amount of leaf debris it accumulates ($750-3500).

The motor is hot, and the bearings sound to be in poor condition ready for re pack ($500+) Recommend upgrading the status of this pump by doing the bearing service ($500).

Also note the pump is sitting on blocks, less than ideal for long term use, can be re positioned for approx $500.

Pump lid o ring is leaking, recommend service.

Also note a better variable speed pump would be the best value at approx $1100-2800.

Currently leaking from pump seal plate / lid o ring / return fitting.

The booster pump operates without issue. Recommend hard plumbing the hoses soon for longevity ($500).

The timers are like new. The power shut off switches are older. There is no GFCI compliant breakers installed, recommend upgrading for safety ($500+).

The pool equipment pad is fairly small and the plumbing appears to be older than 15 years. I would recommend optimizing this equipment pad by removing old copper? Gate valves, Painting & labeling the equipment pad, And optimizing where the equipment is located to avoid trip hazards and easy access to the filter pump basket that has to be cleaned weekly ($1000+).

Otherwise no issues present currently, but will be of issue soon (1-10 years).