The surface is older than 20 years, likely older than 30 years. It is worn, mostly in the deep end on the walls. Overall the surface is nearing its expected life / poor condition - estimated cost to re plaster is 10-12k+.

The waterline tile is compromised on the north east side Of the pool, the concrete also has caused shifting and movement of the bond this area approximately10- 30% of the pool Tile will need to be re-done ($5-7k+). During repair Recommend considering servicing the rest of the tile and/or updating ($750-2500+).

Also note the concrete around the pool on the east side affected by the movement near the tile failure will likely need to be redone or jacked ($2k-5k+).

The water quality indicates that the pH and alkalinity are slightly high and needs to be modified ASAP ($20). Also, the Cyanuric acid and calcium hardness levels are slightly low, but within ideal range - recommend a minor edition of approximately $30 in chemical (cya). And special note that there is black algae present to specially seen on the walls and deep end and very small spots recommend ongoing treatments to resolve this which will likely start with approximately $375+ in chemicals

The main drain in The Pool is ready to be updated for safety $100. Note that at re-Plaster, it will be to be updated to a VGBA compliant drain.

The skimmer is very old / poor / damaged condition and will and should be updated at re-Plaster stage ($1500-3500+) At that time, consider adding an independent main drain line if possible.

The skimmer has all parts needed for proper operation.

There is no bottom cleaner unit installed in the swimming pool, but there is a booster pump installed on the equipment pad, but since the booster pump on the equipment pad is not working recommend simply installing a suction side bottom cleaner here instead ($650+) The Pool Cleaner 4 Wheel - at the one and a half inch wall adapter threaded fitting.

The manual fill located in between the house and the pool is leaking during use recommend minor service to resolve this leak so you can use this manual fill at your leisure without issue ($125-250+).

Likely the filter elements are due for updating ($150-450+)

This is the oldest variable speed on the market. Still in working condition. But currently the pump basket is completely full - recommend service ($10) to resolve also likely new lid o ring / service ($50).

I was unable to get the bottom cleaner pump to turn on, likely the pump may have expired ($1250+) or electrical may be disabled. The pump looks new which is why I feel it may not be a failed pump vs electrical. Recommend service call to confirm ($125+).

We have Older timer boxes located near the pool equipment - They are heavily rusted due to chemicals being stored inside this equipment room. It is likely that these timers are no longer being used as actual timers, but instead bypassed. Still, it would be ideal if they were properly covered and or waterproof with some protective paint ($150).

I also did not find a GFCI rated breaker for the variable speed or pool lights recommend updating and install installing those for safety. $300 +

The equipment pad is covered from UV quite efficiently. I would simply label the pad further ($50) and note that Some of the equipment was plumbed in low quality abs and will need updating (pump return $200+).