The surface appears to be between seven and 15 years old with a thin layer of mottling presents on the surface, giving it a whiter hue.

And some locations mostly in the deep end I am seeing where a 3 inch chlorine tablets sat on the surface for a prolonged period of time, and essentially wore through the mottling and expose the lower base color of the surface (dark grey) in more than one location.

Overall the surface appears to have some scratches present on it, likely from the bottom cleaner losing its wheel, but overall the surface does appear to be in expected condition for its age, without any major abnormalities.

Typically plaster last up to 30 years, if well-maintained therefore the surface appears to be halfway through its lifecycle.

Special note that there is approximately 20-50% coverage of landscape debris on the surface.

The tile on this pool appears to be in Ideal Condition and Overall.

The water quality is indicating that some modification will be required to enjoy the pool less than $50

Due to the amount of foliage presents in the water, the main drain cannot be seen fully, and or the skimmer.

It does appear that we likely have three main drain covers in the pool that are due to be updated for safety ($88x3).

The bottom cleaner unit appears to be between 2 to 5 years old+ It appears it will need a new tail and service soon ($105).

This light appears of water present inside the light lens recommend updating for safety ($750+).

The filter is operational at this time however, it is due for its elements likely to be updated $400 and likely the tank O-ring pressure gauge updated as well $100.

Special note that I personally would not recommend updating this filter due to its age and condition, and instead change it to a sand filter, like the TR 100c by Pentair

It does appear that this pump may have had its drive updated. Either way this pump is in working condition without any issue at this time.

Also note that the conduit going to this pump is heavily sunburned, and should be updated for safety ($200).

This pump is in working condition however, it is showing signs of old age - likely since this pump doesn’t get a lot of use it has managed to survive in working condition. It would be wise to update the conduit going to this pump as it is heavily sunburned ($200).

The filter pump is communication wire directly into the solar, touch solar control system by Pentair.

The controller is in working condition.

The power shut off timer is also in working condition.

The GFI to the pool light and the GFCI for the pool pump should be updated for safety ($250).

The pool equipment pad has been sun blasted, and should be updated with the UV paint and relabeled ($200).

Also, some items like the check valve times two should be updated as well ($500).