The surface is older it is likely worn down to the lowest surface, the Gunite in some locations that is likely the darker color seen in 10 to 50% of the pool. To replaster a pool of this size I would estimate it to cost $8-12k.

The tile does have calcium buildup present, mostly seen in the Waterfall area.

Overall, the tile appears to be original, and in fair condition

Currently, the water level in the pool is very high up to the maximum level.

On the northeast section of the pool there appears to be some type of sticker / tape applied from maybe a leftover project - unsure.

The waterfall stone and rock work around the pool appears to have been re-mortared in the past 10 years, but there are still some sections that may need attention in the next five years or less ($500+).

Recommend adding chemicals needed ($100) to help balance the water then re checking water chemistry again in 1-30 days to confirm water loss status.

The main drain cover in the pool is due to be updated for safety ($88+).

The skimmer lid, basket, weir, and float valve are all due to be updated ($200).

Special note, the main drain cover is a safety hazard and will need updating ASAP as it is an entrapment hazard specifically the pipe proximity to the cover itself.

The skimmer has a shortened expected life and should be updated at replaster stage.

The skimmer is older, proximately 15 years or older, with chlorine wear present throughout likely due to 3 inch chlorine tablets being present. There are also tablets present currently.

The in floor cleaning system is no longer operational. Therefore, I feel the best recommendation here is a robot style bottom cleaner.

Non working. Recommend update.

The filter is in operational condition. The connections coming in and out of the filter Likely need to be updated soon as seen on the pump with the gray piping ($250+).

At the same time, recommend updating the pressure gauge and it is likely that the element inside the filter is due to be updated if it hasn’t been done in the past 1 to 3 years ($200+).

The filter pump is in working condition without issue at this time.

The timer is missing its protective plastic shield. I can easily be purchased online for less than $15 from Amazon.

In general, this box is in poor condition, but can likely last another decade, if sanded and painted ($100+).

I also am concerned with the conduit no longer connected to the filter, pump, conduit run, and the wire type inside the conduit it may be required that this is updated ($200).

There is an active GFCI present.

The plumbing overall is older, but might just simply need a new fresh coat of paint, and to be relabeled ($200). There is an infloor cleaning system installed that is also older, and may be recommended to simply remove the internals to allow this to function resistance free ($100). Or if that isn’t an option, removing the canister completely, and installing T’s to the return lines ($200+).