The surface of the pool is heavily, worn, scratched, and there are what appears to be potential cracks throughout. In the deep end, there are also considerable amount of calcium Fisher’s present. Where the spa connects to the pool there is a crack on that wall in several locations.

It is likely the surface will need to be redone ($12k+) as well as potential structure repairs ($5k+) to shore up crack issues.

The majority of the waterline tile around the pool is in fair condition for its age.

The spa spill over tile area will need to be re-finished due to cracks present ($2500).

There is some lifted concrete on the east side of the pool recommend repair as it is a trip hazard currently ($2500+)

The water is not balanced and will need approximately $100 and chemicals to properly balance. Note that the low cyanuric acid and calcium hardness levels indicate water, loss or new water is present.

Both main drain covers are due to be updated ($88x2).

The skimmer is older and heavily chlorine damaged. Recommend updating the internal components ($300+).

Poor condition overall. Recommend replacement ($650+).

The fill is leaking during use and when not in use recommend repair ($250).

There is water present inside the light lens. Recommend replacement for safety ($750).

The spa light also has water present inside the light lens recommend replacement ($750)

The filter is running very high pressure, indicating that the elements will need to be replaced soon and the filter serviced ($750).

This pump is a poor quality I would anticipated this lasting another one to six months before replacement will be required ($1500+).

Booster pump is in working condition however, it is vibrating and leaking indicating that the bearings are worn and likely will fail soon. Repalcment is $1250+.

While the spa jet pump is in working condition, it is older, and will likely need to be updated soon.

During the inspection, the heater was working without issue.

The equipment panel is older, and the breakers need to be updated for safety ($150+).

The panel is not setup correctly with wiring as it functions in several unusual ways ie booster timer not functioning correctly ($150+).

the Valving installed is older and will need to be updated. Note the pool is copper and will need to be updated to pvc during remodel phase ($10k+)