The surface overall is relatively blemish free. There are some rust stains present in the north west section of the pool that ideally can be removed with service ($400+).

There are some blemishes present on the steps in the shallow end edge.

There are some blemishes on the north east side of the pool.

The tile overall is in relatively good condition. There is a section of water stuff that is coming off in the west section of the pool that can be fixed easily ($100).

Water quality is indicating that the pH and alkalinity is high likely due to salt cell usage and the cyanuric acid level is slightly low due to water loss potential - recommend addition of chemical ($100).

Both skimmers need new floats and float O-rings ($300). Also both skimmers likely need some fresh mortar inside the throats ($300).

The bottom cleaners in working condition however recommend updating the hose swivels ($100) as the hose is becoming entangled on itself.

The auto fill was running during the inspection which is generally an indicator of water loss being present recommend service to the auto fill itself to confirm issue ($125+).

The pool lights are in working condition.

The filter is due to have it’s drain plug assembly updated as well as its pressure gauge assembly updated ($300).

This filter pump needs to be properly connected to the structure bonding wire not just the panel, also recommend updating the lid o ring, the return connection (which two appears to have been a plus B epoxy which is very bad and may require pump replacement ($2700+), and a new check valve ($1200).

The panel has been overheated and therefore no longer in working condition as it is very difficult to determine the display recommend updating ($1450+).

At the same time recommend updating the breakers to variable speed compliant breakers ($300+)

The salt cell is newer than seven years however it is likely due for updating in the very near future ($850+ install = $1200).

Valving installed is due to be serviced and updated in several locations which will include removing the random accessories that are no longer installed and capping appropriate junctions ($1200).