Surface has some blemishes present in the middle of the pool on the east wall. Also there appears to be some blemishes presents on the steps specifically in the north part of the pool and the middle south part of the pool. The north steps have likely scratches from an unknown reason. The surface appears to be between 7 and 15 years old. Typical items that will cause the surface to expire prematurely are high pH high cyanuric acid and low flow which all three are present in the swimming pool.

The waterline tile is an ideal working condition. There is significant calcium buildup present throughout especially on the east wall. Recommend removing the calcium ($750).

The waterfall spi overs look like they are made of stainless steel this is typically isn’t an issue unless it is a high chlorine pool. The North Spillover appears to be having issue Vs the south.

We have very high chlorine and high cyanuric acid. Recommend modification to water chemistry / 1/4 drain ($250+).

The water quality isn’t immediately showing us signs of water loss however recommend rechecking water chemistry in one to 30 days as well as the auto fill.

The two main drain covers in the deep end of the pool likely need to be updated due to age and condition ($88x2).

The skimmer has some leak repair work performed to it, and therefore will need to be either re-repaired ($450+) or the skimmer replaced ($2500). Replacement will be permanent wall repair will only last 1 to 5 years.

Additionally the skimmer float and float O-ring will need to be replaced ($200).

The cleaner appears to be in working condition with debris in the bag however the booster pump would not turn on during service therefore It cannot be properly tested.

It does appear to be in good working condition.

The auto fill is currently running generally indicating that a leak may be present, recommend cleaning and servicing fill to confirm issue ($125).

Both pool lights appear to be in working condition.

Filter is in working condition and the filter pressure is lower indicating that the elements were likely cleaned recently and or replaced. I would recommend replacing the pressure gauge and servicing the unit to confirm element life ($125).

This filter pump is working the motor Drive has paint peeling off of it generally due to high heat conditions the pump is 2009 and due to high heat conditions I would not expect it to last another 1 to 5 years without issue. Estimated cost to replace is $2200.

I was not able to turn on the booster pump through the panel or remote. It does appear the bottom cleaner is in working condition as there is debris in the unit therefore this booster pump is likely working. The cost to replace the booster if failed is $750- $1250.

The ultra pure water sanitizer is no longer operational recommend replacement if desired ($800-1500).

The board breaker and GFCI breaker for the plug is in working condition. Recommend updating the breaker for the variable speed pump to GFCI ($150).

The salt system is older than seven years and is no longer in working condition. Even though the indicator lights would convince you otherwise the salt cell will only last up to seven years therefore replacement is required now or nearly tomorrow ($850).

The plumbing installed is in working condition without any leaks present however it is due to be painted labeled and covered from UV ($400).

There also is five valves and unions that will need to be serviced ($500).

Last there is a plumbing repair that is not ideal and will need to be cut out and replaced ($400).