The fencing is in good working condition however it isn’t in ideal self closing condition. Minor repairs to accomplish this.

The surface is in ideal condition for its age. It does have discoloration due to high ph / high chlorine. There are blemishes in the shallow end most likely due to objects falling and landing directly on the plaster surface. If in the future the blemish gets worse a simple plaster repair can be performed to correct.

Minimal calcium build up, approx cost $300-450 when the time is desired.

The water quality overall isnt bad, it does have a high cyanuric indicating that a 1/2 drain should be performed to balance. And a lower calcium hardness indicating new water in the past 3 - 12 months. Or since the filter is leaking this could be a prolonged leak causing significant water to be lost over time, recommend adding water and maintaining chemical level and testing again in 1 - 3 months.

The skimmer has discoloration throughout due to improper water chemistry / chlorine tablets being placed in the skimmer basket. This should be corrected by replacing / servicing the skimmer o ring and float valve ($155) for now,

eventually the skimmer will need replacement, ideally in 10 - 25+ years but due to discoloration potential is much sooner ($2-3K).

The main drain is not VGBA compliant and should be upgraded for safety ($25 cover - 225 service)

The unit is in working condition , however heavily damaged by chemical (chlorine/salt), note replacement is the most ideal option for this situation I feel. As repair to unit would most likely be extensive ($250+ Hose, Tail, bearings, tires, wheels, etc+).

Broken / Too Easily Removed Auto Fill Valve Topper to Valve, also leak located on the plastic flush valve body, may need simple flush out or seal replacement ($125 Service Call)

Fully functioning light, no issues at this time. Note however due to age of the light (approx 10-12 years) that the light is set to expire any moment or up until ten years from now. Approx cost for standard 500 watt/300 watt Incandescent $575 Installed, $1375 for Color Changing LED Pentair Light Installed

The filter is in a distressed state, as its been in the sun since 2002, and its currently leaking from its main tank seal as well as the pressure gauge assembly at the top of the filter ($255). Note after addressing all of these leaks the issues may still persist as the top of the filter is prone to morphing over time as its such a small piece of plastic and so much pressure is applied to it daily, if un maintained.

If desired a Sand Filter TR 100 would be an ideal filter in this situation with a multi port backwash valve in line, as easy and clean of a filter as you can have. Coupled with a variable speed or 1/2 or 3/4 hp pump this would work well.

The filter pump overall is in fair to good condition, however;

1. The motor is a level 4 out of 4 on heat 212+ and will cause this motor to expire if left un resolved. Most likely cause of issue; A. Dirt Filter Elements B. Older motor (original motor) and at one point or another it was ran dry causing the bearings to fail, and causing more resistance to be applied to this normaly smooth motor or C. Incorrect plumbing size in relation to native GPM of this pump: This pump motor is WAY oversized for the plumbing , and its literally carving groves into the plumbing and adding un needed pressure to the system every time its ran. In other words, please remove this pump and replace with ideal pump; IntelliPRO $1675, Intelliflo, Superflo VS, or Superflo 3/4hp $575 in order of cost, highest to lowest.

Solution would be to service motor

The board and timer are in working condition, however the breakers / light plug breakers are not GFCI compliant and should be updated for safety ($245) otherwise no working issues at this time.

Overall the pool equipment is in fair condition however there needs to be a plumbing modification as it’s not ideal for filtration; ($455).

UV Paint $155

Valve & O Ring Service $455

= $1065 To bring back to like new