OPINIONS: It was explained by the Owner that the pool was re-plastered approximently one year ago. The color of the new plaster is referred to as "Tahoe Blue". In the application of this plaster color, it is to be expected that light and dark variations will result over time, referred to as "mottling".
Although we would not expect to see what is referred to as "check cracks" throughout the entire pool's interior surface. These together with the water stains, which are indicative of residual water accidentally coming out of a pipe during the plastering process are not generally acceptable as meeting the industry's minimum quality control standards.
National Swimming Pool Plastering Council
Pool Interior Finishes are composed of materials which may have inherent shading and/or color variation which is normal and should not be construed as a defect. Environmental factors such as humidity, temperature, substrate conditions, etc., during the installation process can cause normal color variations (normal mottling) across the surface of a coating. This is generally a uniform shading or cloudy appearance. These variations may be more pronounced on a cloudy day or at night with the light on. These conditions are beyond the contractor’s control. Discoloration or mottled-shade variation is not considered a failure or defect, but is characteristic of most cementitious products, not needing remedy. It is a normal occurrence of most exposed aggregate finishes to have variation in the surface aggregate density, or variations in the concentration of aggregates across the finished surface. Proper evaluation of an interior finish is done when the pool is full of water and under natural light conditions only. The pool interior finish is NOT guaranteed for evenness of color and may not be the exact shade anticipated. The shade and color of pigmented surfaces will vary and “fade” over time.
Crazing (check cracks and hairline cracks), may be noticeable and may be quite pronounced with colored finishes and are normal and are not considered defects.
It is highly recommended to perform a start-up procedure on freshly plastered pools, such as the NPC Start-up Procedure. A proper start-up will promote a longer lasting interior finish.
The longevity of the surface will be dependent on the water chemistry after start-up being properly maintained in accordance with the Association of Pool & Spa Professionals (APSP) published standards recommended practice of maintaining the Langlier Saturation Index at 0 to +/- 0.5. Overall common water chemistry parameters to be monitored are: chlorine, total and carbonate alkalinity, pH, calcium hardness, cyanuric acid and total dissolved solids.
Things that should be VERIFIED prior to plastering;
TESTING OF FILL WATER
AFFIRM PLASTER SAND / CEMENT RATIO
MFG. OF PLASTER PRODUCT
MONITOR HYDRATION OF PLASTER MIX
CHECK TO MAKE SURE ALL INLET / OUTLET PIPES ARE DRY.
WEATHER CONDITIONS (WIND /DRY / WET / HOT / COLD)
CREW STRENGTH AT TIME OF APPLICATION
DURATION BETWEEN START TO FINISH
DETERMINE SPAN OF TIME TO FILL POOL
POOL WATER TEMPERATURE DURING CURING
MAKE SURE ALL EQUIPMENT IS OPERATIONAL
It is not possible during our inspection to know whether or not all of the aforementioned were properly performed prior to applying the plaster but, due to the amount of "check cracking" it is our opinion that an underwater dye test could help to determine whether or not the pool's plastering surface is still water tight, as well as investigating any possibilities of any delamination of the plastering surface.
|