Wooden fence in fair to poor condition needs minor repair to allow self-closing and self latching ($125).

Plaster overall is in fair condition, with only one blemish , deep end wall, this is a structure issue as it has been left to degrade for longer than 5 years, and should be repaired asap, and ideally when pool is replastered in 12 - 72 months as this repair is approx 1/3 the cost of an entire re plaster.

Water loss present, may be due to open solar valving , and not a closed / working valve.

The water has high chlorine, low calcium hardness and low low cynuric, indicating water loss is present.

Recommend re balance ($155).

The skimmer is not in working condition as its missing all items needed for proper working condition; skimmer float, skimmer weir, and skimmer float o ring.

The main drain is therefore not functioning and the main drain cover is also not in safe working condition and not VGBA complaint. Recommend upgrading this for safety.

Also the two water fall pump suction flow main drain covers are not VGBA compliant. Recommend 3x new cover.

Unit is in fair condition, recommend tune up service to re balance this unit and replace several parts under $20 - totalling approx $105-205.

The units wheel cover (or hub-cap) is also found in the main drain area.

Fiber tower , white light, in good working condition, tower needs to be cleaned inside of debris and animal debris ($55-155).

The filter needs service ($45-125) the tank o ring needs service and the filter elements most likly need cleaning now ($85) or replacement ($650) soon 1 - 24 months.

The filter pump has seen significant sun exposure (7-15 years) and the pump is most likely in need of a shaft seal repair due to the high heat from the worn out motor ($285) and to add a new shaft seal is $355 installed.

Heat level a 2 out of 4 indicating some motor stress, due to age I would anticipate this pump lasting another 1 - 48 months without issue. Then a new motor may be required ($285).

The timer is in, fair working condition, this is a "hot job" modification to the timer that is supposed to be inside this housing. Recommend buying the proper timer clock housing insert ($110) for this timer, or keep it exactly the same, it should function relativity well assuming a wire nut doesn't fall off and electrify this metal insert, and a small service call fee to possibly do it ($155).

This unit functions the actuator and solar assemblies, however since there is no water in the solar collectors to test the temp sensor connections, showing working on the display unit.

The equipment pad is heavily covered with landscape debris, and can not be fully tested.

Recommend removing all this debris ($155).

Painting the equipment pad ($155).

Replacing all non serviceable check valves ($255 x 3).

And replace all o rings and service all o rings ($355).