The plaster surface has some signs of wear specifically on the top step out of the spa there are some small pets potentially exposing the Gunite layer underneath also on the top step of the pool there is heavy discoloration due to chemical in balance and salt cell chlorine distribution over all the plaster appears to be in fair condition however there are several areas that can be corrected for a cost less than $500 to allow this plaster to potentially last another 7 to 15 years without issue.

Fortunately there is black algae buildup throughout the swimming pool specifically around many of the plastic eyelets I go into the pool recommend brushing off all black algae while doing an underwater algae treatment ($355) to potentially eliminate all black algae.

The skimmer basket is near impossible to remove recommend replacing with a smaller skimmer basket that is ideal also it is missing its skimmer we are in skimmer flow valve recommend replacement.

The spa and the pool main drain's appear not to be 2 feet apart therefore they are not VGBA compliant recommend installing the VGBA complain drain covers for safety.

This bottom cleaner is in good working condition however many parts need replacement due to age and poor condition ; wheels, swivels, tail, and most likely hose ($210). A new unit like this one cost approximately $450 however with maintenance this unit typically lasts forever as all parts are designed to be serviceable every 5 years ($100).

The float is in poor condition due to tape thing added to the float recommend replacement float ($10).

Due to poor water quality and higher filter pressure filter element replacement would be reckoned ($255). At that time consider tank o ring replacement ($55) and pressure gauge replacement ($10).

This pump is in good working condition however there is a leaking shaft seal that needs service ($285). Otherwise in good working condition.

Heater turns on and functions normally.

There is no drip leg for the gas line, therefore one needs to be installed ($155).

The timer board is in working condition, with no issues found. It runs all operations and all sensors are operating except the salt cell / flow switch, as outlined in the Salt Control System section.

The salt system is connected to the main panel the main panel does not detect any salt cell power indicating the salt cell is Bad ($450).

Recommend 10 year valve service ($455) and re paint with UV paint ($175).